Dynamix DW 2 FXO Manual de usuario descargar pdf (Pagina 88)

Dynamix DW-2FXS/2FXO Gateway (H.323) User Manual

Parameters Usage:

-print print current h323 related settings

-mode alternatives for gatekeeper or peer-to-peer mode (0=gatekeeper

mode; 1=peer-to-peer mode). If users select gatekeeper mode, a

valid gatekeeper is needed when Gateway is in operation.

-----------------------------------------------------------------------------------------------

usr/config$ h323 –mode 1 (peer to peer mode)

-gk to assign gatekeeper’s IP address when Gateway is in gatekeeper

mode.

-algk assign second gatekeeper’s IP address as redundancy. If

Gateway fails to register to main GK for 10 time, it will try to

-gwtype gateway type has two kinds, gateway and terminal. Gateway

type – device will register as H.323 defined Gateway, user has to

define [prefix] in next command.

Terminal type – device will register as H.323 defined Terminal,

[prefix] command is not necessary.

-dfgw default gateway is applied under Peer-to-Peer mode. User defines

a constant default gateway IP address, then any number dialed if

the number is not listed in phone book table will pass forward to

this IP Address.

-prefix assign Gateway prefix number, as well as the registered number

on the Gatekeeper.

-line1 assign FXS TEL1 number.

-line2 assign FXO Line1 number.

-line3 assign FXS TEL2 number.

-line4 assign FXO Line2 number.

Note:

User can also set “x” in line number to disable the port. If the port is

disabled, it can only receive calls but not calling out.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 121 122

Sin comentarios

Dynamix DW 2 FXO Manual de usuario Pagina 88