Dynamix 4-Band VDSL CO/CPE Modem Guía de usuario

 XL-VCQ102SB 4-band VDSL CPE/Slave bridge User’s Guide 

3.Hardware Description This section describes the important parts of the Modem. It features the front indicators and rear connectors. Front Ind

Front Indicators LED Description and Operation The Modem has three LED indicators. LEDs Status Descriptions Ready (Ready LED)Steady Green It w

Rear Panel The following figure shows the rear connectors Figure Chapter 2.3 Rear Connectors Modem Rear Side Connectors Connectors Descript

4.Applications APPLICATION FOR HOME NETWORKING The 10Mbps Modem is used to connect any device equipped with a standard 10/100Mbps Ethernet port t

Appendix A: Cable Requirement A CAT 3,4 or 5 UTP (unshielded twisted pair) cable is typically used to connect the Ethernet device to the Modem.

Standard telephone wire of any gauge or type-flat, twisted or quad is used to connect the Modem to the telephone network. A telephone cable typically

Appendix B: Product Specification Product NameVDSL To Ethernet Modem (VDSL Modem) ApplicationHome networking solution Product Specification Compl

Power Consumption: 2.5W Chipset : Infineon 10Base-S 16

Appendix C: Troubleshooting Diagnosing the Modem’s Indicators The Modem can be easily monitored through its comprehensive panel indicators. These

2.7 Verify the VDSL switch and VDSL Modem during the same speed mode. You can select VDSL Speed mode by 10 Mbps. 2.8 speed mode can link and work

VDSL Point to Point Solution The VDSL (Very High Data Rate DSL) networking solution delivers cost-effective, high-performance broadba

Disable and enable CPE LWD 19

System Diagnostics Power and Cooling Problems If the POWER indicator does not turn on when the power cord is plugged in, you may have a problem

Physical Configuration If problems occur after altering the network configuration, restore the original connections, and try to track the problem

Appendix DLink Recover Procedures Operating Procedures: 1. Power on VDSL CO, start the speed change program, change speed mode to 4/1Mbps. 2.

Appendix EAccessories-Bracket Two Brackets The brackets are specially designed to fix the VDSL Modem on the table to avoid someone t

Appendix FCompliance and Safety Information FCC Radio Frequency Interference Statement This equipment has been tested and found to comply with th

Important Safety Instructions CautionThe direct plug-in wall transformer serves as the main disconnect for the product. The socket outlet shall be

FCC Warning This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules

Warranty The original owner that the product delivered in this package will be free from defects in material and workmanship for one year parts a

Foreword The VDSL Modem is an Ethernet to VDSL adapter that enables high speed internet access to building residents, campuses students and hotel

Contents 1.Unpacking Information Check List --------------------------------------------------------4 2.Installation Hardware Installation--------

1.Unpacking Information Check List Carefully unpack the package and check its contents against the checklist. Package Contents • Ethernet to VDSL

2.Installing the Modem Hardware Installation This chapter describes how to install the Modem and establishes network connections. You may install

General Rules Before making any connections to the Modem, note the following rules: • Ethernet Port (RJ-45) All network connections to the Modem

Connecting the RJ-11/RJ-45 Ports 1.The Modem’s RJ-11 ports support the transmission of data up to 10Mbps across existing phone wiring, without in

3.The RJ-11 port support 10 Mbps connections. When inserting a RJ-11 plug, be sure the tab on the plug clicks into position to ensure that it is pr