Dynamix UM-SB Manual de usuario descargar pdf (Pagina 137)

DynamixUM‐SNBUserManualVer1.00136

5.8 Upgrade

This section will introduce how to upgrade the kernel and FPGA code of G.SHDSL .Bis NTU. Select upgrade in main menu and

press [ENTER] or [RIGHT].

Please notice that when you use Remote Upgrade feature. It means you can use that feature to update firmware to remote side.

It will be describes below.

During an upgrade and re-flash, the normal transmissions will be halted, so the upgrade should be done when the system is

taken offline or done during a time of extremely low impact to the line of customer.

The upgrade procedures use the Xmodem protocol via the serial console port of rear panel.

Following show the upgrade feature:

Before upgrading the NTU, you must have the main software or FPGA code in your computer.

If you want to upgrade the kernel code: select Kernel and press [ENTER] or [RIGHT].

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 163 164

Sin comentarios

Dynamix UM-SB Manual de usuario Pagina 137