Dynamix DW 4 FXO Manual de usuario descargar pdf (Pagina 18)

Dynamix IP PBX-100

Extension Number: Assign the number of Extension. This number is also the register name

for device.

Password: Assign the register password for device to register on IP PBX-100.

DialPlan: Define the dialing pan for Extension. It specifies the location of the instruction used

to control what the phone is allowed to do, and what to do with incoming case for this

extension. In phase 1, there is only one dial pan called [from-internal].

Keypad: User can select Keypad type to be RFC2833, In-band, or SIP-lnfo. The setting

should be also match the Keypad setting of Extension device.

NAT Traversal: If the Trunk device is behind a device performing NAT, such as firewall or

router, and need to register to IP PBX-100 on public network, then user has to enable this

function. Enable NAT Traversal to force IP PBX-100 to ignore the contact information for the

Extension and use the address from which the packets are being received.

RTP Mode: User can choose for two type of RTP mode, one is Routed Mode another is

Direct Mode. The voice media will be routed "Peer-to-Peer" if two clients are both setting to

Direct Mode. This way will improve the voice quality and reduce the performance wastage

oftheIP PBX-100.

Note:

• If one peer set to Direct Mode but another peer set to Routed Mode, the result will

become to Routed Mode.

• Voice media will still go through the IP PBX-100 if the IP PBX-100 needs to detect

DTMF.

• If you enable the NAT Traversal function for Extension, the RTP mode will change

After press Modify can input detail setting for Extension.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 68 69

Sin comentarios

Dynamix DW 4 FXO Manual de usuario Pagina 18