Dynamix DW 4 FXO Manual de usuario descargar pdf (Pagina 24)

Dynamix IP PBX-100

Note:

• When a cal was sent form IP PBX-100 to a remote SIP-Trunk, the SIP-Trunk may

attempt to authenticate the "cal". So IP PBX-100 should reply the correct Account ID

and Password. How does the IP PBX-100 know which ID and Password it should

send? When the cal is going to SIP-Trunk via ePBX, the SIP-Trunk may reply a 407

code which will contain a parameter called "Realm" for authentication, IP PBX-100

will re-send the cal again and contains correct ID and Password based on the

Realm. So the Realm should be unique. For more information about Realm, please

contact with your ITSP.

• If you have multiple IP PBX-100, you may hope those IP PBX-100 could cal to each

other. You should set the Extension to let those IP PBX-100 can register to each

other, and you should also confirm the [Realm] in the page of Configuration^ IP

PBX. For more information, please refer to the Appendix A: Application

between Dynamix DW CPE device and I P P B X - 1 0 0 .

Status: Once SIP Trunk is configured and enabled, here will show the registration status.

Press Apply to save configuration, or press Cancel to quit configuration.

3.1.5 Routing Table

Routing Table is to set routing rule of IP PBX-100. There are two directions to set rules:

Outgoing Cal Rule means from subscriber (Extension or Trunk registered on IP PBX-100) to

cal out. Incoming Cal Rule means cal from other non-subscriber device to IP PBX-100.

Enter Configuration ■* Routing Table-select direction and press Add New to set

routing table.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 68 69

Sin comentarios

Dynamix DW 4 FXO Manual de usuario Pagina 24