Dynamix DW 4 FXO Manual de usuario descargar pdf (Pagina 26)

Dynamix IP PBX-100

pease set this parameter as 0. The maximum length is 20.

Note:

• If you set the Digits Length as a specific value, such as 1, the dialed

number should ful match to 1, or you can set the Digits Length to 0 to ignore

the digits length.

Primary/Secondary/Third: User can set three priorities for each routing rule, if IP PBX-100

fails to route to primary destination three times, it will try to route to secondary or third

destination.

Destination: Here you can find some destination (Trunk) for choosing. You can define the

destination for the prefix route.

Note:

• Before setting the Routing Table, vou should set the Trunk info in the page

of Trunk first. So that this field will contain the Trunk ID for choosing.

• If the Trunk was setting to Dynamic in the Host field, but it doesn't register on IP

PBX-100, IP PBX-100 will skip this priority and route cal to next priority

immediately without trying. If the Trunk was setting to Address in the Host field,

but the Address is not reachable, IP PBX-100 will try three times then route cal to

next priority.

Drop: To drop specified length of number. For example, you set 2 here and the called

number is 03123, the IP PBX-100 will drop 03 then send 123 as outgoing number. Add: To

add assigned number. For example, you set 02 here and the called number is 03123, the IP

PBX-100 will add 02 then send 0203123 as the called number.

Note:

• If you set both of the Drop and Add, IP PBX-100 will Drop first then Add.

Example:

If user set prefix as 002, digits length as 12, Primary destination as 888, Drop as 3, and Add

as 0.

When caller called 002912345678, the prefix is 002; length is 12, so this cal matches the

routing rule.

002912345678–912345678(Drop 3 digits) –0912345678(Add 0)

Finally, IP PBX-100 will send 0912345678 to Trunk ID 888.

Route Password: Set password here so the IP PBX-100 will request password before

sending the cal to Trunk.

Guest Allow: Enable Guest Allow will a l l o w user who is not your subscriber (Extension) to

use such routing record. User can reach the Auto attendant (The default Auto Attendant of IP

PBX-100 is **999) first then send cal to Destination (Trunk) if you enable Guest Allow. If you

disable Guest Allow, only the Extension can use this Routing record.

Note:

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 68 69

Sin comentarios

Dynamix DW 4 FXO Manual de usuario Pagina 26