Dynamix DW 4 FXO Manual de usuario descargar pdf (Pagina 22)

Dynamix IP PBX-100

if you set empty here.

Note:

• Normally, SIP From URI will contain the Extension's calling ID and ePBX's IP

address, but some ITSP may reject this cal due to some security issue. You can

modify the Calling ID and IP/ Domain in the fields of [External Server Address] and

[Outbound Caller ID] when the cal is going via the ePBX to the Destination (Trunk)

to avoid such security issue.

• If you set a Dynamix DW FXO gateway as the Trunk, you can just use the default

Trunk 888 and 889 as the FXO's register number.

• For the FXO gateway, you may just configure Extension Number, Password, Host:

Dial Plan, Keypad, NAT Traversal and RTP Mode.

• If you set the ITSP as the Trunk, you may need to set the following configure: Port,

External Server Address and Outbound Caller ID.

• For more information, please refer to the Appendix A: Application between

Dynamix DW CPE device and e P B X - 1 .

Press Apply to save configuration, or press Cancel to quit configuration.

3.1.4 SIP Trunk

SIP Trunk is for IP PBX-100 to register to other systems only, such as ITSP or

another IP PBX-100.

On screen of SIP Trunk will show al of the sets of SIP Trunks. You will find out the

registered Account and registered server IP address, port number, Realm and the Register

Status. User can press Add New to add new Trunk or Modify to configure the specified SIP

Trunk. Press Delete will delete the specified SIP Trunk.

Enter Configuration SIP Trunk-Add New to configure IP PBX-100 register to ITSR ITSP

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 68 69

Sin comentarios

Dynamix DW 4 FXO Manual de usuario Pagina 22