
Dynamix IP PBX-100
28
• For more information, please refer to the Appendix A: Application between
Dynamix DW CPE device and IP PBX-100.
Press Apply to save configuration, or press Cancel to quit configuration.
3.1.5.2 Incoming Call Rule
Incoming Cal Rule means cal from other non-subscriber device to IP PBX-100.
For example, you set the IP PBX-100 to register an ISTP as a SIP Trunk, so your IP
PBX-100 could be as an "Extension" of ITSP. The other subscriber of ITSP could cal to IP
PBX-100 by the registered line number, when the IP PBX-100 got an incoming cal which is
not its own subscriber, what will the IP PBX-100 do? The IP PBX-100 will perform the
following action based on the "Incoming Cal Rule".
The above example means the ePBX-10 got a called number 7070, which was not sending from a "Extension",
ePBX-10 will drop 6 digits then add **999 as the destination number. **999 is the default number of auto
attendant. So the caller will hear greeting because the called number will be routed to auto attendant.
Prefix: Set prefix number for routing rule.
Digits Length: Set the length of dialed number, if user doesn't want to limit the length, please
set this parameter as 0. The maximum length is 20.
Note:
• If you set the Digits Length as a specific value, such as 1, the dialed number
should ful match to 1. or you can set the Digits Length to 0 to ignore the digits
Comentarios a estos manuales